How to maintain the glue filling equipment correctly

When using glue filling equipment, manufacturers must require regular maintenance work on the equipment. Although it may delay some time, as the saying goes, sharpening the knife does not delay the woodcutter. Only through reasonable maintenance of the equipment can the use of the dispensing equipment achieve better dispensing effects and also extend the service life of the equipment.

1. Daily maintenance and upkeep involve a lot of content, such as a machine cannot use one type of glue for a long time, and a factory cannot produce only one type of product for a long time. Sometimes, it is necessary to replace the glue inside the machine. Therefore, before replacing, all residual glue inside the machine and pipelines should be cleaned thoroughly, This can prevent the two types of glue from mixing together and affecting the quality of the product

2. If abnormal air pressure or a large amount of water vapor is found during the use of the glue filling equipment, the water in the pressure regulating filter of this product should be thoroughly drained, and then the air pressure device should be checked for any abnormalities

3. If a large amount of gluing work is required, a small batch of debugging should be carried out before the work. If the product is found to be qualified through small batch debugging, large-scale production can be carried out. If the product produced during the debugging process is found to be unqualified, it should be stopped from use and then inspected to identify the cause of the product's unqualified. If it is the cause of the glue machine, it should be debugged to ensure the smooth operation of the machine

4. When the machine is stopped for a long time, the power should be unplugged. This not only prolongs the service life of the glue filling equipment but also saves a lot of electricity bills. With the rapid development of industry, liquid control technology and dispensing equipment are constantly evolving towards ultra-high precision control, diversification, and specialization

5. To replace the adhesive, clean the pipeline. At this point, first close the feed valve, open the discharge valve, discharge the remaining rubber material from the rubber bucket, close the discharge valve, open the feed valve, pour the cleaning solvent into the rubber storage bucket, activate the machine body, and press the solvent out and rinse according to the usual operating method

6. Please regularly wipe the machine part clean to increase its service life. The more glue is mixed together, the faster the reaction and curing speed will be. Therefore, it is necessary to make a reasonable mix of glue according to the actual production situation, otherwise it will cause waste of glue

Nowadays, liquid control technology and dispensing equipment are widely used in various production fields in modern industry. In addition, the glue filling equipment should be cleaned properly after each use, and visible parts should be wiped with alcohol. The frequently moving parts need to be lubricated with engine oil or butter.