What maintenance methods should be used for the glue dispenser

The editor of HOLS (Suzhou) believes that the daily maintenance of the glue dispenser directly affects its service life. The daily maintenance of the glue dispenser has a significant impact on its service life, including the smoothness of daily use. The following are the daily maintenance steps for the glue dispenser:

1. Change the type of adhesive and clean the pipeline. At this point, first close the supply valve, open the discharge valve, discharge the remaining adhesive from the bucket, close the discharge valve, open the supply valve, put the cleaning solvent into the storage bucket, activate the body, and rinse the solvent according to the usual operating method

When there is abnormal air pressure intake or water vapor is found, please discharge the water vapor from the pressure regulating filter or check if there is any abnormality in the air pressure source. Before using a large amount of glue, please conduct a small amount of testing to master the product's usage skills to avoid errors. When there are no problems with the test, use a double liquid drip glue machine or double liquid filling glue machine for mass production; The vacuum pumping system vacuums and removes bubbles from the adhesive to eliminate them during the mixing process, or allows it to stand for 10-20 minutes before use, allowing the bubbles generated during the mixing process to be discharged in a timely manner. The more bubbles generated during the mixing process

The machine should be regularly wiped to extend its service life. The more glue is mixed, the faster the reaction and the faster the curing rate. Therefore, it is necessary to mix glue reasonably according to the actual production situation, otherwise it will cause glue waste. Eliminate accidents and improve production efficiency. Nowadays, liquid control technology and filling equipment are widely used in various production fields of modern industry

When the machine is shut down for a long time, the power should be unplugged. This not only extends the service life of the machine, but also saves a lot of electricity costs. With the rapid development of industry, liquid control technology and dispensing equipment are also constantly evolving to ultra-high precision control, diversification, and specialization

The editor of HOLS (Suzhou)  reminds everyone to pay attention: the glue dispenser should be cleaned thoroughly after each use, and all visible areas should be wiped clean with alcohol. It is best to lubricate areas that frequently move with oil or butter. If not used for a long time, it must be polished, otherwise it will solidify in the glue dispenser and need to be cleaned again.